Support Structures
Last updated
Was this helpful?
Last updated
Was this helpful?
Support structures are essential for printing models with overhangs, bridges, or complex geometries. Proper configuration balances structural integrity, material efficiency, and post-processing ease. Key parameters include overhang angle thresholds, support placement, interface density, and separation distances.
Standard Definition: The angle between a surface and the vertical axis (0° = vertical). Supports generate when this angle exceeds the Maximum Overhang Angle (MOA).
Slicer Variations:
Bambu Studio/Orca Slicer: Angle measured from the build plate (90° = no support needed).
Cura/PrusaSlicer: Angle measured from vertical (45° = default threshold).
PLA: Supports typically trigger at 55–60° with active cooling, enabling steeper overhangs.
ABS/ASA: Lower thresholds (40–45°) due to reduced cooling and higher warping risk.
Calculation Method:
α=arctan(d⋅(1−f)h)α=arctan(hd⋅(1−f))
Where αα = MOA, dd = extrusion width, ff = outline overlap (default 33%), hh = layer height.
Example: For d=0.4mmd=0.4mm, h=0.2mmh=0.2mm, and f=0.33f=0.33:
α=arctan(0.4⋅0.670.2)≈53°.α=arctan(0.20.4⋅0.67)≈53°.
Everywhere: Supports generated under all overhangs (default for complex models).
Touching Buildplate: Limits supports to areas connected to the build plate, reducing material use.
Pattern Selection:
Zig Zag: Balanced strength and material efficiency.
Grid: Enhanced stability for heavy overhangs.
Lines: Minimal material usage for low-stress areas.
Tree: Generates tree like structures to reduce the amount of material used.
Function: Creates a dense, smooth layer between the model and support for easier removal.
Settings:
Interface Density: 75–100% for clean surfaces.
Interface Layers: 2–4 layers to ensure consistent contact.
Material Considerations:
Soluble Materials (PVA, HIPS): Ideal for intricate supports.
Standard Filaments: Use lower interface density (50–75%) to simplify removal.
Definition: Vertical gap between the support and model, set as a multiple of layer height.
Typical Range: 0.5–2× layer height (e.g., 0.2mm for 0.2mm layers is a great starting point).
Adjustments:
Too Low: Supports fuse to the model, complicating removal.
Too High: Sagging or poor surface quality.
Purpose: Horizontal gap to prevent nozzle collisions or making support too difficult to remove.
Recommended: 0.8–1.2mm for most materials; increase for small features to avoid unnecessary supports.
Advantages: Reduced material usage and easier removal for organic shapes.
Optimization:
Z Distance: 0.5–2× layer height. Generally around 0.2mm is a good starting point.
Branch Density: Lower for flexible filaments (e.g., TPU).
Arc Overhangs: Specialized algorithms print overlapping arcs to eliminate supports for internal geometries.
Bridging: Modify geometry to reduce support dependency.
Active Cooling: Maximize fan speed for PLA overhangs; minimize for ABS to prevent warping. Cooling will always help to print steeper overhangs but will reduce layer adhesion on most materials.
Layer Time: Increase minimum layer time (5–15s) to improve cooling on small features.
Solutions:
Increase Support Interface Density (e.g., 80–100%).
Reduce Z Distance by 0.05–0.1mm.
Increase cooling if possible with material being used.
Adjustments:
Increase Z Distance by 0.05–0.1mm.
Lower Interface Density or use soluble materials.
Prevention:
Increase Support Density to 15–20%.
Use Grid or Cubic patterns for stability.
Add brim for support.
